It's apparent the bug is getting worse as Affinity Designer comes out with new versions.
I apologize for not providing images from version 1., but take the images below and imagine even more is cutoff.
#Cetus3d model out of print range 3151 pdf
Unfortunately the only way to print from Affinity Designer in the last two versions is to do a PDF export and print from Adobe Acrobat or other PDF reader. Printing in Affinity Designer is no good until the developers address this major print issue. It looks like a printing bug is spanning multiple versions of Affinity Designer which I am saddened to know about. Going through print dialog again and preview, sure enough my border is cutoff. I then put an inside aligned black outline around the right most element to see if the print is being cutoff. I noticed that a little of the right side of my page is short, but not as bad as in 1. I reopened the same file used in my opening thread above, opened Print, then Print to get my preview. This now explains why my prints were shifted off center. was present and found the bug less pronounced, but still present. I've posted this on the 1.9.2 release thread (duplicate), but had second thoughts on the critical importance of this bug being overlooked there, so I created this topic in hopes to avoid this being overlooked. If the Affinity team is onto fixing this in the next day, then I may wait for the update while hobbling along on PDF exports for printing. I couldn't find a similar bug for 1.9.2 on the forums so my guess is it's not been spotted yet. Is there any other way to downgrade other than uninstalling, reinstalling 1.9.1, and re-entering the registration keys?
#Cetus3d model out of print range 3151 install
I just tried to install the 1.9.1 version over the 1.9.2 and I get a "Setup failed" error.
The workaround involved exporting the project as a PDF and print via Adobe Acrobat. After checking the document size settings, scaling, and any other print setting affecting items printing larger than specified, everything was at nominal values used in prior versions not suffering this bug. Upon printing I noticed the right and bottom of the print were cutoff. To be specific, I created a Letter document and populated it with an array of equally sized blocks for printing. Long story short, items in Designer print out larger than set and thus get cropped out of print range on the right and lower edges. On print preview within Designer no red lines showed any overprinting errors. I noticed a major print scaling bug in the program. After updating Affinity Designer from 1.9.1 yesterday to 1.
0 kommentar(er)
